All Categories Production Steps

Tascus production sequences are built using ‘Steps’. Each step type performs a different function from displaying work instructions to operators, to capturing shop floor data......

published on March 2, 2021

The Calculation Step will perform a mathematical calculation using values. To configure this in the sequence editor, select measurements and click the edit icon for......

published on March 21, 2022

This step allows you to capture an image using a camera connected to the station computer. When the step runs, it will display a feed......

published on March 2, 2021

The Counter Step could be used to track a product through an operation without Work Instructions or Data Capture sequence steps....

published on August 9, 2023

Enhance MES production by adding a "Create Label" step to your sequence. This example demonstrates two start options: "Work Order" and "Barcode Only," enabling tailored......

published on November 14, 2023

Using the Display Work Instruction step will allow you to present media files to the operator during production. - Display Work Instruction Overview - Advanced......

published on March 2, 2021

The Furness Leak Test connects to the FCO730 device: https://www.furness.com/product/fco730/ You must Configure and Diagnose the Furness Leak Test before use....

published on August 2, 2023

The If-Or step can be used in combination with numeric measurements or calculations and preconditions to create custom rework logic. This simple example sequence shows......

published on November 30, 2021

The Loop step type can be used to repeat the same step multiple times to record and collect data. From the Sequence Editor, select Loop......

published on August 2, 2023

This step enables an operator to enter a numeric value and have that recorded against test limits....

published on March 2, 2021

Pass/Fail Test enables you to prompt an operator to perform a test and say if it’s Passed or Failed. Test Instructions – This is the......

published on March 2, 2021

This step displays a box at which an operator or supervisor must log in again to confirm that a process has been completed. At this......

published on March 2, 2021